Installation Instructions for Compatible Scooter Variator Kit 8.5g for 50cc 4 Stroke Engines

Preparation Before Installation:

1. Tools Required:

   • Socket set (including 8mm and 10mm sockets)
     -Torque wrench
   • Screwdriver set (flathead and Phillips)
     -Pliers
   • Rubber mallet (optional)
     -A clean cloth or rag
   • Safety goggles and gloves

2. Safety Precautions:

   • Ensure the scooter is on a flat, stable surface.
   • Disconnect the battery to avoid any electrical shorts during installation.
   • Wear safety goggles and gloves to protect yourself.

Installation Steps:

1. Remove Variator Cover:

   • Using the socket set, remove the screws holding the variator cover in place.
   • Carefully take off the cover and set it aside.

2. Remove Old Variator:

   • Use the socket set to loosen the variator nut. If it's stuck, you may use a rubber mallet gently to help it come loose.
   • Remove the variator and set it aside for comparison.

3. Install New Variator:

   • Take the new 8.5g variator from the kit and place it in the same position as the old one.
   • Ensure that it fits snugly and there are no obstructions.

4. Replace Variator Nut:

   • Secure the variator in place by tightening the variator nut using your torque wrench. Follow the manufacturer's specifications for torque settings.

5. Reattach Variator Cover:

   • Place the variator cover back over the variator and secure it with the screws using the socket set.

6. Reconnect Battery:

   • Reconnect the scooter's battery and ensure that all connections are secure.

7. Final Checks:

   • Double-check all screws and nuts to ensure that everything is properly tightened.
   • Perform a brief test run to make sure the scooter operates smoothly.

Conclusion:
Your new Compatible Scooter Variator Kit is now installed and ready to enhance your scooter's performance. Remember to periodically check the installation for any loose components and perform maintenance as needed. Enjoy your ride!