Motorcycle Air Filter Dustproof Sand Cover Installation Instructions

Tools Required:

1. Screwdriver (flathead or Phillips, depending on your motorcycle)
2. Adjustable wrench or socket set
   3.Clean cloth or paper towel
3. Motorcycle owner's manual (for reference)

Installation Steps:

1. Prepare Your Motorcycle:

   • Ensure your motorcycle is on a stable surface and the engine is turned off and cool to the touch.
   • Disconnect the negative terminal of the battery as a safety precaution.

2. Remove the Existing Air Filter:

   • Locate the air filter housing using the owner's manual for guidance.
   • Use the screwdriver or wrench to remove any screws, clamps, or bolts securing the air filter housing.
   • Carefully take out the existing air filter and set it aside.

3. Clean the Air Filter Housing:

   • Use a clean cloth or paper towel to wipe down the air filter housing, removing any dust or debris inside.

4. Install the Dustproof Sand Cover:

   • Take the Motorcycle Air Filter Dustproof Sand Cover and position it over the air filter housing.
   • Ensure that it fits snugly and correctly in place.

5. Reattach the Air Filter Housing:

   • If applicable, replace the air filter back into the housing, followed by reattaching the dustproof cover.
   • Secure with screws, clamps, or bolts to ensure a tight fit.

6. Reconnect Battery:

   • Reconnect the negative terminal of the battery.

7. Final Checks:

   • Start the motorcycle and check for any unusual noises or issues.
   • Ensure the dustproof sand cover is properly installed and that the air filter is functioning without any obstructions.

8. Regular Maintenance:

   • Periodically check the dustproof sand cover for dirt accumulation and clean as necessary to maintain optimal engine performance.

By following these steps, you will successfully install the Motorcycle Air Filter Dustproof Sand Cover, providing enhanced engine protection and extending the life of your air filter. Enjoy your improved riding experience!