Installation Instructions for Compatible Motorcycle Chain Slider Seal Guard

Compatible Models:
125cc and 150cc motorcycles including XR125L, NXR125, and NXR150.

Tools Required:

1. Socket Wrench Set - For removing and attaching bolts.
2. Screwdriver Set - To help with any additional screws.
3. Torque Wrench - To ensure bolts are tightened to the correct specifications.
4. Pliers - Useful for handling any clips or securing fasteners.
5. Clean Cloth - To wipe down surfaces before installation.
6. Protective Gloves - To keep your hands clean and safe during the process.

Installation Steps:

1. Preparation:

   • Make sure the motorcycle is parked on a flat surface.
   • Use a clean cloth to wipe the area where the chain slider will be installed.

2. Remove Old Chain Slider (if applicable):

   • Use the socket wrench to unscrew any bolts holding the old chain slider in place.
   • Carefully remove the old slider and clean the area thoroughly.

3. Install the New Chain Slider Seal Guard:

   • Position the new chain slider seal guard in place.
   • Align it with the existing holes, ensuring a snug fit.

4. Secure the Guard:

   • Use the socket wrench to tighten the bolts securely, but be cautious not to overtighten.
   • If applicable, use pliers to secure any clips.

5. Final Check:

   • Double-check all connections and ensure that nothing is loose.
   • Ensure that the chain runs freely and is not obstructed by the new guard.

6. Test Drive:

   • Take the motorcycle for a short test drive to ensure proper installation and performance.
   • Listen for any unusual noises that may indicate improper positioning.

Maintenance Tips:

• Regularly check the chain slider for wear and tear to ensure continued protection.
• Clean the chain area periodically to prevent dirt and debris buildup.

By following these instructions, you will enhance the performance and lifespan of your motorcycle chain while ensuring a clean and safe riding experience.