Product Installation Instructions for Motorcycle Chain Slider Seal Guard (125cc Models 2003-2008)

Tools Required:

1. Socket Wrench Set - For removing and securing bolts.
2. Phillips and Flathead Screwdrivers - For adjusting any screws if necessary.
3. Torque Wrench - To ensure bolts are tightened to the manufacturer’s specifications.
4. Pliers - Useful for any grasping or pulling needs.
5. Cleaning Cloth - To clean areas before installation.
6. Protective Gloves - To keep your hands safe and clean during the installation process.

Installation Steps:

1. Preparation:

   • Begin by ensuring the motorcycle is on a flat surface and securely parked.
   • Use the cleaning cloth to wipe down the area where the chain slider will be installed.

2. Removing the Old Chain Slider:

   • Use a socket wrench to remove any bolts or screws securing the old chain slider.
   • Carefully pull the old slider away and set it aside.

3. Installing the New Chain Slider Seal Guard:

   • Take your new chain slider seal guard and align it with the designated installation area.
   • Secure it in place using the appropriate bolts or screws. Make sure to hand-tighten first.

4. Tightening:

   • Once the slider is aligned correctly, use the torque wrench to tighten the bolts to the recommended specification. This ensures a secure fit without stripping the bolts.

5. Final Check:

   • Inspect the installation to confirm that the chain slider seal guard is firmly in place and aligned properly with the chain.

6. Test Ride:

   • After installation, take a short test ride to ensure everything is functioning correctly. Listen for any unusual sounds and check for proper operation.

7. Maintenance:

   • Regularly check the condition of the chain slider seal guard and maintain it as necessary to ensure long-lasting performance.

By following these steps and using the required tools, you will ensure your new Motorcycle Chain Slider Seal Guard is installed correctly, enhancing your riding experience and prolonging the life of your motorcycle.