Product Installation Instructions for Universal Motorcycle Air Intake Filter Cleaner

Compatibility:
This air intake filter is suitable for multiple 250 and 300 models from 2008 to 2018, ensuring broad compatibility.

Installation Steps:

1. Preparation:

   • Make sure the motorcycle is parked on a flat and stable surface.
   • Allow the engine to cool down if it has been recently used.

2. Required Tools:

   • Screwdriver set (Phillips and flathead)
     -Socket wrench set
     -Clean cloth
   • Motor oil or silicone spray (for sealing, if necessary)
   • Safety goggles and gloves (recommended)

3. Installation:

   • Locate the stock air intake filter in your motorcycle. This is usually found in the airbox, accessible through the side panel or seat.
   • Carefully remove the screws and components securing the air intake filter cover.
   • Gently take out the old air filter and clean any debris from the airbox with a clean cloth.
   • Take the new air intake filter and apply a light coating of motor oil or silicone spray on the sealing edges, if required.
   • Insert the new air intake filter into the airbox, ensuring it fits snugly and securely.
   • Reattach the air intake filter cover and secure it with screws.
   • Double-check that all components are tightly fastened.

4. Final Check:

   • Start the engine and let it idle for a few minutes to ensure everything is functioning properly.
   • Listen for any unusual sounds or vibrations that may indicate a loose fit.

5. Maintenance:

   • This filter is reusable and can be cleaned. Follow the manufacturer's cleaning instructions to maintain optimal performance and extend the filter's life.

Note:
Always refer to the motorcycle’s service manual for specific details about the air intake system and installation procedures for your model.

By following these steps, you will enhance your motorcycle's air intake system, improve fuel efficiency, and elevate overall performance.