Motorcycle Air Filter Installation Instructions for TTR250 (2000-2006) and WR250 (2009-2020)

Tools Required:

1. Screwdriver Set - To remove screws securing the air filter cover.
2. Wrench Set - For any bolts that may need to be removed.
3. Clean Cloth - To wipe down the air filter compartment and remove any debris.
4. Vacuum Cleaner or Air Compressor - To clean out any dust or debris before installing the new air filter.

Installation Steps:

1. Preparation

   • Ensure the motorcycle is on a stable surface and the engine is cool.
   • Gather all required tools and the new air filter.

2. Remove the Air Filter Cover

   • Locate the air filter cover on your motorcycle.
   • Use the screwdriver or wrench to remove the screws or bolts securing the cover.

3. Take Out the Old Air Filter

   • Carefully lift out the old air filter from its housing.
   • Discard the old air filter properly.

4. Clean the Air Filter Compartment

   • Use a clean cloth to wipe down the inside of the air filter compartment.
   • If available, use a vacuum cleaner or air compressor to remove any excess dust or debris.

5. Install the New Air Filter

   • Place the new air filter into the compartment, ensuring it fits snugly and aligns properly.
   • Make sure there are no gaps around the edges of the filter.

6. Reattach the Air Filter Cover

   • Secure the air filter cover back in place using the screws or bolts you removed earlier.
   • Ensure it is fastened tightly to avoid any air leaks.

7. Final Check

   • Inspect the installation to ensure everything is in place and securely fastened.
   • Start the motorcycle and let it idle for a few minutes to ensure it runs smoothly.

Maintenance Tip:

• It is recommended to replace the air filter every certain mileage, depending on riding conditions, to keep your engine operating at its best.

By following these instructions, you can easily install your new motorcycle air filter for optimal engine performance.