Product Installation Instructions for Compatible CVT Drive Belt for 50cc 10 One 729171 Engine

Tools Required:

1. Socket Wrench Set (including various sizes)
2. Screwdriver Set (both flathead and Phillips)
3. Pliers (for gripping and pulling)
4. Torque Wrench (to ensure proper tightening)
5. Safety Goggles (to protect your eyes during installation)
6. Gloves (to protect your hands and ensure a better grip)

Installation Steps:

1. Preparation:

   • Park your motorcycle or scooter on a flat surface.
   • Ensure the ignition is turned off and the engine is cool to prevent burns.

2. Remove the Cover:

   • Use the socket wrench to remove the bolts securing the CVT cover.
   • Carefully take off the cover and set it aside.

3. Remove the Old Belt:

   • Inspect the old CVT drive belt and note its position.
   • Using pliers, carefully release any tension and remove the old belt from the variator and clutch.

4. Install the New Belt:

   • Position the new compatible CVT drive belt around the variator and clutch.
   • Ensure that the belt is seated properly in the grooves of each component.

5. Reassemble the Cover:

   • Once the new belt is installed, place the CVT cover back on.
   • Use the socket wrench to secure the cover with the bolts, ensuring they are properly tightened.

6. Final Checks:

   • Double-check that the belt is aligned correctly and has the right tension.
   • Wear safety goggles and gloves for added protection while performing these checks.

7. Test the Vehicle:

   • Start the engine and test the vehicle to ensure proper operation with the new belt.

Note: Always refer to your vehicle's user manual for specific guidelines related to your model for additional details and safety information.

By following these steps, you can successfully install the Compatible CVT Drive Belt, enhancing the performance and longevity of your motorcycle or scooter.