Product Installation Instructions for Universal Front Fork Oil Seal Dust Covers for Motorcycles

Compatibility:
This universal front fork oil seal dust cover is compatible with a wide range of motorcycle models from 1999 to 2019, covering the 125-690 series.

Tools Required:

1. Wrench Set: To loosen and tighten bolts.
2. Screwdriver Set: For any screws that may need to be removed.
3. Pliers: Helpful for gripping and holding components in place.
4. Rubber Mallet: To gently tap components without causing damage.
5. Cleaning Cloth: To clean any surfaces before installation.
6. Grease: To lubricate the seals for easier installation.
7. Safety Goggles: To protect your eyes during installation.

Installation Steps:

1. Preparation:

   • Ensure your motorcycle is parked on a stable surface and secure.
   • Clean the area around the fork seals with a cloth to remove any dirt or debris.

2. Remove the Old Dust Covers:

   • Use the appropriate wrench or screwdriver to detach any components obstructing access to the dust covers.
   • Carefully pry off the old dust covers using pliers if necessary.

3. Install the New Dust Covers:

   • Apply a thin layer of grease to the inner edge of the new dust covers.
   • Align the dust covers with the fork tubes and gently press them into place. Use the rubber mallet if needed for a snug fit.

4. Reassemble Components:

   • Reattach any components that were removed during the disassembly. Ensure all bolts and screws are tightened securely.

5. Final Check:

   • Inspect the installation to ensure the dust covers are properly seated and there are no gaps.
   • Test the motorcycle's fork movement to ensure smooth operation.

Conclusion:

With the right tools and following these steps, you can easily install the Universal Front Fork Oil Seal Dust Covers. Enjoy enhanced protection and improved performance of your motorcycle!